National Instruments PC-DIO-96 Bedienungsanleitung PDF herunterladen (Seite 19)

2-1 PC-DIO-96 User Manual

Chapter 2

Configuration and Installation

This chapter describes the PC-DIO-96 jumper configurations, installing the PC-DIO-96 board in

your computer, signal connections to the PC-DIO-96 board, and cabling instructions.

Board Configuration

The PC-DIO-96 contains one DIP switch and one jumper to configure the base I/O address and

interrupts, respectively. The DIP switch and jumper are shown in the parts locator diagram in

Figure 2-1.

The PC-DIO-96 is configured at the factory to a base I/O address of hex 180 and to interrupt

level 5. These settings (shown in Table 2-1) are suitable for most systems. However, if your

system has other hardware at this base I/O address or interrupt level, you need to change these

settings on the PC-DIO-96 (as described in the following pages) or on the other hardware.

Record your settings in the PC-DIO-96 Hardware and Software Configuration Form in

Appendix D, Customer Communication.

Table 2-1. PC-DIO-96 Factory-Set Switch and Jumper Settings

Base I/O Address Hex 180

(factory setting)

3 4 5

U26

(The black side indicates the side of the

switch that is pushed down.)

Interrupt Level Interrupt level 5 selected

(factory setting)

W1: Row 5

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 104 105

Keine Kommentare

National Instruments PC-DIO-96 Bedienungsanleitung Seite 19