National-instruments Smart Camera Bedienungsanleitung PDF herunterladen (Seite 2)

NI Smart Camera I/O Accessory User Guide 2 ni.com

What You Need to Get Started

❑ NI Smart Camera I/O Accessory kit, which includes the accessory, 15-pin D-SUB female to 15-pin

D-SUB male cable, 2 m (part number 197817-02), and two-position header connector (Wago part

number 734-102, available from

www.wago.com)

❑ NI 17xx Smart Camera

❑ One of the following power supply options:

Caution Use the smart camera only with a 24 VDC, UL listed, limited power source (LPS) supply.

The power supply will bear the UL listed mark, LPS. The power supply must also meet any safety

and compliance requirements for the country of use.

– NI desktop power supply (part number 780237-01) and power supply cord. Refer to ni.com

for the power supply cord part number specific to your region and ordering information.

– Any 24 VDC, +20%/–15% (IEC 1311) power supply, such as the PS-5 power supply (part

number 778805-90), and custom power cable. Refer to the Building a Custom Power Cable

section for information about building a power cable for the NI Smart Camera I/O Accessory.

❑ (Optional) NI 9-pin female D-SUB to 9-pin female D-SUB null modem RS-232 cable

(part number 182238-xx)

❑ 0.125 in. flathead screwdriver

❑ 12–28 AWG wire

❑ Wire cutter

❑ Wire insulation stripper

❑ Related documentation—The following documents, available from ni.com/manuals, contain

information you may find helpful as you set up and use the NI Smart Camera I/O Accessory:

– Getting Started with the NI 17xx Smart Camera

– NI 17xx Smart Camera User Manual

Safety Information

Caution The following paragraphs contain important safety information you must follow when

installing and operating the device.

Do not operate the device in a manner not specified in this document. Misuse of the device can result in

a hazard. You can compromise the safety protection built into the device if the device is damaged in any

way. If the device is damaged, return it to National Instruments (NI) for repair.

Do not substitute parts or modify the device except as described in this document. Use the device only

with the chassis, devices, accessories, and cables specified in the installation instructions. You must have

all covers and filler panels installed during operation of the device.

Do not operate the device in an explosive atmosphere or where there may be flammable gases or fumes.

If you must operate the device in such an environment, it must be in a suitably rated enclosure.

If you need to clean the device, use a soft, nonmetallic brush. Make sure that the device is completely

dry and free from contaminants before returning it to service.

1 2 3 4 5 6 7 ... 10 11

Keine Kommentare

National-instruments Smart Camera Bedienungsanleitung Seite 2